Roof Tiles
	Roof Tile Plaster for press moulds For manufacturing of moulds used in roof tile manufacturing To select the right product, normally the plaster used for top-moulds have a higher porosity than plaster for bottom moulds. In case there is a vacuum created for the bottom moulds, the porosity of both plasters can be similar. Product Plaster / Water Ratio Pore Volume (%) Brinell hardness, dry (MN/m²) Product Datasheet Safety Datasheet Heliodur 40 FE    1.85 - 2.00:1 39 39 — Teha G 47    2.00 - 2.20:1 35 57 — Teha B    2.20 - 2.40:1 28 74 Teha BG    2.20 - 2.40:1 30 74 Teha BGL    2.20 - 2.40:1 32 75 Teha C    2.30 - 2.60:1 25 109 Teha CG    2.30 - 2.60:1 26 109 Teha CGL    2.30 - 2.60:1 28 110 Teha    3.00 - 3.33:1 16 195 — Teha G    3.00 - 3.33:1 16 195 Teha GL    3.00 - 3.33:1 17 197 — Teha 28    3.00 - 3.57:1 15 210 Molda Dur    1.75 - 1.85:1 31 39 Molda Marbre    2.90 - 3.30:1 21 120 Molda Alfapress    2.90 - 3.30:1 21 120 Alfamolde 4    2.90 - 3.30:1 21 120 — All values are average values; for precise product specification see the Product Datasheet listed. Roof Tile Plaster for casted ornaments For manufacturing of moulds used for roof-ornaments To select the right product, normally the plaster used for top-moulds have a higher porosity than plaster for bottom moulds. In case there is a vacuum created for the bottom moulds, the porosity of both plasters can be similar. Product Plaster / Water Ratio Pore Volume (%) Brinell hardness, dry (MN/m²) Product Datasheet Safety Datasheet Almod 60    1.20 - 1.45:1 50 21 Alfor    1.45 - 1.56:1 44 23 Supraduro    1.49 - 1.61:1 43 25 All values are average values; for precise product specification see the Product Datasheet listed.       back to top